Mini Mambo quick start guide for assembly.  Do visit the web site at happyRCFlyer.com for the additional files and instructions referenced to aid in assembly.  Files only folder is at HappyRCFlyer.com/mini-mambo

"Refer to the Print Files for parts placement".

Refer to the build thread here for a more grahical view: https://www.rcgroups.com/forums/showthread.php?4350581-Mini-Mambo-new-laser-cut-kit-creation-and-build and feel free to sign up with the forum and get involved as well.  The stabalizer is a bit different then normal construction systems, so please review this build log prior to continuing.

Join fuselage sections together, add 1/8" strips of balsa lengthwise where they join. Glue in the thin hardwood reinforcement stock in their respective positions where the wing meets the sides of the fuselage, leaving the top rail stock out to cut and fit into shape after the formers are in place.

Add 1/8" strips of balsa along the top and bottom of former sections.

Place aft fuse former and front former/motor-mount former into their respective slots.  Position the fuselog sides square and pin the end section together.  Glue in the two formers.

Add the additional formers and light ply firewall.

Add the tail section mounting stock.  

Optional thin ply stock is included to suppliment the tail fin mounting tabs as desired.

The wing plan supplied should be assembled, the circles show alignment upon where to cut and join the sheets of stock.

Build each wing half, do not glue in center ribs. Using 1/4x1/4 stock for the leading edge and lower spar.  Use the dihedral bracing stock for the proper angle where the leading edge and lower spar join in the middle.

The wing tips are angled at builders discretion.

Add upper spars, overlapping in the middle.

Place center ribs into place, do not glue in yet., Only one only is needed, second is supplied optionally for use.

Add dihedral bracing stock and join the wing halves. Glue the overlapping top spars together.

Glue in center ribs.

Add 1/32" sheeting to the center leading edge.  Add 1/32" sheeting to center trailing edge. Top and bottom if preferred.

More instructions added based upon request. If any of this seems too far out your capacity, please do not hestitate to reach out to me for additional support.  (360) 949-3662, Brian@happyRCFlyer.com, espressooutfitters@gmail.com.