Reference the ongoing add on’s with the Slow stick Jenny folder for additional photo’s, text and otherwise. This is a supplement for the wing and otherwise build aspect upon. https://happyrcflyer.com/jenny-stick-plans
Assemble the plan sheets. There are two wing halves you are going to put together to build upon. Pin them down to your build table with the proper backing upon to pin the stock down. A simple flat board with some foam board to pin it onto will do and wax paper between the plans and the stock to pin down and glue into place.
Pin down the trailing and leading edge onto the plan. Line up the parts to be added and test fit.
Fit and glue the ribs into place along with the wing tip section. Take note of the difference in the rib patterns if it’s not immediately obvious how they interlock. Do NOT glue in the center rib yet, in blue, use it strictly for placement of the spars to come later.
Add the top spars.
Build second wing half.
Glue together center rib. and place between the wing halves as you slide them together, interlocking the spars.
Add the aft sheeting form. Fill in with scrap between the upper and lower half sheeting as necessary or desired. Add the lower spars along with.
